Lincoln Electric IM351 LN-7 GMA Wire Feeder - Manual (Page 11)

A-4 INSTALLATION
LN-7 & LN-7 GMA
A-4
5. Connect the input control cable polarized
Amphenol plug into the mating 6-pin receptacle
on the rear of the control section.
6. Referring to Figure A.2, install the input cable
under the wire reel mounting stand strain relief
clamp. Remove the screws holding the clamp to
the base of the wire reel mounting assembly, put
the input cable assembly under the clamp and
reinstall the screws.
STRAIN
RELIEF
CLAMP
CONTROL
CABLE
ELECTRODE
CABLE
FIGURE A.2 – STRAIN RELIEF CLAMP.