Lincoln Electric IM823 LN-15 WIRE FEEDER - Manual (Page 13)

A-4 INSTALLATION
LN™-15 ACROSS THE ARC MODEL & (CE)
A-4
Work
Clamp
Electrode Cable
Electrode Cable
Electrode Cable
Work
Clamp
Work
Clamp
wire feeder
K1870-1
wire feeder
K1870-1
RANGER 8
SAE 400 WITH CV ADAPTER
ENGINE DRIVEN WELDERS
WITH WIRE FEED MODULE
(LOCAL MODE AND CV ADAPTER)
CV250
CV300
CV400
CC POWER SOURCE
Output Output Terminals erminals
Always Hot. Always Hot.
Output Output Terminals erminals
Always Hot. Always Hot.
Output Output Terminals erminals
Always Hot. Always Hot.
Order K484 Jumper Order K484 Jumper
Plug Kit.
Plug Kit.
Electrode Cable
Work
Clamp
semiautomatic
semiautomatic
semiautomatic
semiautomatic
wire feeder
K1870-1
wire feeder
K1870-1
wire feeder
K1870-1
CV655, DC400, DC600,
DC655, V350-PRO,
RANGER 9, RANGER 300 DLX
COMMANDER 300
COMMANDER 500
RANGER 250
RANGER 305G
Output Output Terminals erminals
Always Hot. Always Hot.
Power source contactor Power source contactor
switch must be in the
switch must be in the
"ON" position or use a
"ON" position or use a
K848 Junper Plug Kit. K848 Junper Plug Kit.
CONNECTION DIAGRAM, ACROSS THE ARC MODEL Set-Up ( See Figure A.1)
Typically used for general fabrication, maintenance and repair jobs because it’s easy to set up and operate.
Requires only one cable-less to carry. Contactor standard on Across The Arc Model.
FIGURE A.1
Although a constant voltage (CV) power source is recommended for best results with Innershield® and gas
metal arc (GMAW) open arc welding, satisfactory general purpose welding may be obtained using the LN™-15
with a constant current (CC) power source for non-critical commercial quality mild steel welding applications.