Lincoln Electric IM512 INVERTEC RACKS - Manual (Page 15)

- 8 - INVERTEC RACKS
OPERATION
on the front of the rack. Verify operation of the power
source by listening for fan operation. Turn
“ OFF ” the
power source control switch located on the front of the
rack. Verify operation of remaining power sources in
the same manner.
With all power sources operational, the aluminum rack
or steel rack is ready for use. Each operator indepen-
dently controls their power source with the power
source control switch located on the front of the rack.
See Operating Optional Accessories Section if
you will be using K907-1 Quick Connect Plugs.
TRANSPORTING OR HOISTING RACKS
If the rack needs to be transported in a vehicle or
hoisted to high or low elevations, all power sources
must be firmly secured to the rack per Mounting
Products Supported Section. If hoisting, disconnect
main input lines to rack and output cables of power
sources.
OPERATING OPTIONAL ACCESSORIES
Operating Rack with K907-1 Quick
Connect Plugs
Turn the input power “ OFF ” at the rack ’ s power
source control switch, and the power source switch
before attempting to connect or disconnect K907-1
quick connect plugs for that power source.
Do not lay unused quick connect plugs in puddles,
quick connects must be free of dirt and moisture
before the connection is to be made.
Before operating the rack, turn “ OFF ” the racks
power source control switch for all unused quick con-
nect receptacles.
------------------------------------------------------------------------
WARNING