Lincoln Electric IM500 IDEALARC CV-300 - Manual (Page 33)

F-6 DIAGRAMS F-6
CV-300
CV POWER SOURCE TO AN LN-25 / K444-1
Only qualified persons should install, use or service this machine
.
using the disconnect switch at the fuse box
WARNING
T
urn off input power to the Welding Power Source Before connecting the wire feeder.
ELECTRI
C
SHOCK
CAN KILL
N
.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION.
N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF",
ELECTRODE CABLE
-
+
14 PIN AMPHENOL
POWER SOURCE
CV/CV-I
TO WOR
K
LN-25
WIRE FEEDER
O
PTIONA
L
K
484 JUMPER
PLU
G
O
PTIONAL K864 REMOT
E
CONTROL ADAPTER
W
ITH K444-1 OPTIO
N
N.D.N.D.
N.C.
N.C. CONNECT THE K484 JUMPER PLUG TO THE 14 PIN RECEPTACLE OF THE
K864 REMOTE CONTROL ADAPTER. CONNECT THE 6 PIN PLUG FROM THE LN-25 (WITH K444-1 OPTION) TO THE 6 PIN RECEPTACLE OF THE K864
N
.D. THE POWER SOURCE TERMINALS ARE ALWAYS "HOT" WHEN THE K484 JUMPER
PLUG KIT IS INSTALLED.
REVERSE ELECTRODE AND WORK CABLES AT POWER SOURCE, SWITCH LN-25 POLARITY SWITCH.
REMOTE CONTROL ADAPTER. SWITCH THE POWER SOURCE "LOCAL/REMOTE" SWITCH TO REMOTE.
S20663
CV/CV-I POWER SOURCE TO LN-25 WITH K444-1 OPTION CONNECTION DIAGRAM
6-18-93