Lincoln Electric IM644 Commander 500 - Manual (Page 43)

F-7 DIAGRAMS F-7
COMMANDER 500
CONNECTION DIAGRAM:
WIRE FEEDER "B"
N.B.
602 FEEDER "A"
604
75
76
77
14 PIN AMPHENOL
M17866
N.D. IF REMOTE OUTPUT CONTROL IS USED,
PLACE LOCAL/REMOTE SWITCH IN "REMOTE"
N.E THE OUTPUT CONTROL SWITCH MUST BE IN THE "WELDING TERMINALS REMOTELY
ELECTRODE
WELDER, SPECIAL CARE IS TO BE CAUTION: WHEN MOUNTING ADAPTER TO MACHINE COMPONENTS, SUCH AS/BUT
SCREWS
LN-23P
7-18-98
INSTALLATION INSTRUCTIONS
604
75
602
76
77
N.A. ELECTRODE
WORK
115 VAC AUXILIARY ENGINE WELDER WITH
ELECTRODE
ONTO THE WELDER. THEM TO FASTEN THE ADAPTER KIT ASSEMBLY
2. REMOVE THE THREE SCREWS SHOWN AND USE
HAS A HALF INCH SQUARE HOLE IN IT. ASSEMBLY WITH THE ADAPTER BRACKET THAT
1. REPLACE EXISTING BRACKET ON ADAPTER KIT
TO WORK
ENGINE WELDER
COMMANDER TO LN-23P WITH ADAPTER KIT
or service this equipment. Only qualified personnel should install,use Keep away from moving parts.
Do not operate with panels open.
OPERATING INSRTUCTIONS
Disconnect NEGATIVE (-) BATTERY LEAD before servicing. Do not touch electrically live parts.
CAPACITY FOR THE CURRENT AND THE
N.A. WELDING CABLES MUST BE OF PROPER
DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL
Keep guards in place.
FOR PROPER SIZES. TO FEEDER "A" TERMINAL STRIP IN
N.B. IF ONLY ONE LN-23P IS USED, CONNECT
ADAPTER. DESIRED ELECTRODE POLARITY. POSITION
N.C. USE VOLTMETER SWITCH TO SELECT
THE SELECTOR SWITCH TO "WIRE WELDING
K350-1
CV".
521
FEEDER "B"
LN-23P ADAPTER KIT
521
WARNING
9 CONDUCTOR ADAPTER CABLE
POSITION.
LN-23P
WIRE FEEDER "A"
CONNECTION DIAGRAM & INSTALLATION DETAIL
TAKEN AS NOT TO DAMAGE ANY CONTROLLED" POSITION. NOT LIMITED TO ELECTRICAL COMPONENTS, WIRES OR FUEL TANKS.