Lincoln Electric IM644 Commander 500 - Manual (Page 41)

F-5 DIAGRAMS F-5
COMMANDER 500
CONNECTION DIAGRAM:
N.C.
NOT USED ON COMMANDER POWER SOURCES
}
41
2
N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
N.D.
CONNECT TOGETHER FOR WELDING OUTPUT } 42 VAC OPTIONAL }
4
42
}
4
N.E.
2
31
SPARE
COMMANDER TO K867 ADAPTER CONNECTION DIAGRAM
82
K867 UNIVERSAL
ADAPTER PLUG
7-21-98
81
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
S23988
TO K867
N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY. N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. N.D. FOR WIRE FEEDERS THAT RETURN A SIGNAL FOR WELDING OUTPUT, USE ISOLATION
MIN.
RELAY TO CLOSE LEADS 2 & 4.
10K
75 76 77
TO WORK
ELECTRODE
{
TO WIRE FEED UNIT
POWER SOURCE FRAME CONNECTION WIRE FEEDER VOLTMETER CONNECTION
REMOTE OUTPUT CONTROL
CONNECTS TO (WORK TERMINAL) OF POWER SOURCE
TO WIRE FEEDER
CAUTION : THE ENGINE WELDER OPERATING MANUAL. AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
N.E. REFER TO POWER SOURCE INSTRUCTION MANUAL FOR MAXIMUM AUXILIARY CURRENT DRAW.
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
115 VAC
32
GND
21
TO WORK
ELECTRODE CABLE
14 PIN AMPHENOL
WARNING
Do not operate with panels open. Disconnect NEGATIVE (-) BATTERY LEAD before servicing. Do not touch electrically live parts.
Keep guards in place. Keep away from moving parts. Only qualified personnel should install,use or service this equipment.