Actiontec electronic GE344000-01 User Manual

Page 60

Appendix B Configuring TCP/iP

18. Restart the computer. After the computer restarts, verify the settings. Click

Start, Programs and Command Prompt. At the command prompt, enter:

ipconfig /all

Verify an IP address was received, then close the window.

Windows 2000

Windows 2000 installs with default

TCP/IP

configuration. If the computer is new

with Windows 2000 installed, or Windows 2000 has just been installed on the com-
puter, connect the computer to the Router. No further configuration is necessary.

If the Windows 2000

TCP/IP

settings on the computer have been changed since

installation, the

TCP/IP

settings must be configured. If this is the case, ensure the

Windows 2000 installation disks or CD-ROM is available before beginning, since
some driver information may need to be copied during the configuration process.
If the installed Ethernet adapter was supplied with a driver diskette, it should be
available as well.

☞

Note: When installing any software, consult the user guide and

help files supplied with the software for detailed information.
Actiontec provides the following information as a guideline only.

To configure Windows 2000

TCP/IP

settings:

Click Start, Settings and Control Panel.

When the “Control Panel” window appears, double-click Network and Dial-
Up Connections.