Elitegroup CDC-I (V1.0) - Manual (Page 14)

10
Installing the Motherboard
Installing Memory Modules
This motherboard accommodates two memory modules. It can support two 204-pin
DDR3 SODIMM. The total memory capacity is 4 GB.
DDR3 SDRAM memory module table
DDR3 1066 533 MHz
Installing Hardware
Memory module Memory Bus
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR3 SODIMM.
2 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
3 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
4 Install the DIMM module into the slot and press it firmly down until it
seats correctly.
5 Install any remaining DIMM modules.
* For reference only
Do not remove any memory module from its antistatic packaging
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
DDR3 SODIMM Modules (unbuffered, non-ECC)
Raw Card B=1 rank of x8 SDRAM (double sided)
Raw Card F=2 ranks of x8 SDRAM (double sided)