Battery low warning, Small battery for the real time clock, Battery calibration – Elitegroup 600 User Manual
Page 37
Battery Low Warning
When the pack initially reaches the “Battery Low” state approximately 7
~ 10 minutes of the usable battery life is left.
You will hear an audible beep signal every 1.5 seconds alerting you to the
“Battery Low” status. When the battery power reaches the “Battery Low
Low” status the beeping sound will accelerate.
Your battery now has 1 ~ 2 minutes of battery charge remaining. You
must save your data or connect AC power immediately; otherwise, you
may lose your data.
Sound Meaning
Continuous
beeping every
1.5 seconds
Battery Low: Indicates that there is 7 to10
minutes charge remaining.
Beeping
accelerates
Battery Low Low: Indicates that there is 1
to 2 minutes of battery charge remaining.
Save your work and turn off the Notebook,
or connect the AC adapter.
When there is only one minute of battery charge remaining, the Notebook
will enter suspend mode or hibernate according to Windows setting. You
should connect AC power and resume to save your work.
Small Battery for the Real Time Clock
There is a small built-in battery pack that supplies power to the system in
order to maintain certain system information while the power is off. If the
Notebook is left without a power source for long period of time, this
battery will be exhausted and system information will be lost.
Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's instructions.
Never remove the battery pack while the power is on as this may result in
data loss when the system loses power.
Battery Calibration
The purpose for this process is to provide a long battery life for your
system battery pack.
1.
2.
Turn on the computer, when the text appears, press [Del] or the
[Delete] key until the system enters the BIOS Setup screen, you may
now make the necessary changes.
Press the arrow key until it reaches the “Exit” menu screen.
Again press the arrow key and select the “Battery Calibration”
item.
29