Elitegroup G550 (V1.0) - Manual (Page 93)

3 3 . . Remove the screws that secure the RAM module compartment cover and set it aside in a
safe place.
4 4 . .
5 5 . .
6 6 . .
7 7 . .
8 8 . .
9 9 . .
1 1 0 0 . .
Remove the compartment cover and then angling it up and out.
If you need to install a higher capacity module, gently push the edge clips on both sides to
release the module. Angle the card slightly upward and gently slide it from its edge
connector slot. Store the card in the anti-static bag that contains your new module(s).
To install the new memory card, hold the card with its gold edge connector toward the
edge connector slot of the compartment. To help you orient the cards, the edge connector
has been made with two unequal-length sections. You will only be able to insert the card
in one direction.
Insert the edge connector into the slot. The gold edge connector of the card should not be
visible when the card is fully inserted.
Press the card downward where you should hear an audible click as the latches of the
connector secure the card in place.
Once the module is properly seated, you can replace the cover on this compartment.
Replace and tighten the screw.
81