Atlantis Land DISKMASTER NASF101 - Manual (Page 20)

20
4.6 Maintenance
This page allows you to update NAS dongle firmware, to go back to default setting or
to reboot NAS system.
Follow the steps below to update the loader and firmware for NAS Dongle:
1. Obtain the latest firmware from your vendor.
2. Store the firmware file in your computer and decompress them if
necessary.
3. Browse your system and locate the firmware (BIN file).
4. Click on “Upload”.
5. Confirm the pop-up massage to start the update.
6. Wait and DO NOT click anywhere else or turn off the power! This might
take a few minutes.
7. Once the update is done, it will prompt you to reboot the device.
8. Click on ”Reboot” to restart the device.
9. Wait for about one minute and then go to the status page to confirm the
update is successful.