Brocade Multi-Service IronWare YANG Configuration Guide (Supporting R05.6.00) - Manual (Page 48)

40 Multi-Service IronWare YANG Configuration Guide
53-1003038-02
Full examples
3
The following example shows the complete CLI for an interface configuration.
Brocade# show run
Current configuration:
!
ver V5.2.0T183
!
!
no spanning-tree
!
!
vlan 1 name DEFAULT-VLAN
!
vlan 2
untagged ethe 1/6 to 1/8
router-interface ve 2
!
!
system-max vlan 4095
system-max virtual-interface 4095
!
aaa authentication enable default radius tacacs+ local
aaa authentication login default local radius tacacs+
aaa authentication login privilege-mode
aaa authorization exec default tacacs+ radius
aaa accounting commands 0 default start-stop radius
aaa accounting exec default start-stop radius
aaa accounting system default start-stop radius
radius-server host 10.20.99.135 auth-port 1812 acct-port 1813 default key 0 rxperf
tacacs-server host 10.20.99.135 auth-port 49 default key 2 $VUNTblVH
sntp server 10.20.99.135 4
sntp server 10.20.99.130 4
enable snmp config-radius
enable aaa console
console timeout 5
logging host 10.20.99.136
logging console
username brocade password .....
username nclocalnormal privilege 5 password .....
username nclocalsuper password .....
ip route 0.0.0.0/0 10.20.96.1
!
!
!
!
!
snmp-server
snmp-server community ..... ro
fdp run
!
netconf server
!
!
!
!
!
!
!
interface management 1