Brocade Flush Mount Rack Kit Installation Procedure (Supporting VDX 6710-54, VDX 6720-24, VDX 6720-60, VDX 6730-32, VDX 6730-76, and VDX 6740) - Manual (Page 8)

8 of 10 Flush Mount Rack Kit Installation Procedure
53-1002127-04
Attaching rear brackets to a rack
Complete the following steps to attach the rear brackets to the rack.
1. Position the right rear bracket in the right rear of the switch as shown in Figure 4 .
2. Attach the brackets to the right rack upright using three 10-32 x 5/8-in. screws and retainer nuts.
3. Repeat step 1 and step 2 to attach the left rear bracket to the left rack upright.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 4 Attaching the rear brackets to a rack
2 Rear brackets, right (left side similar) 5 Screw, 10-32 x 5/8-in., panhead Phillips
6 Retainer nut, 10-32
2
5
6