Brocade Flush Mount Rack Kit Installation Procedure (Supporting VDX 6710-54, VDX 6720-24, VDX 6720-60, VDX 6730-32, VDX 6730-76, and VDX 6740) - Manual (Page 7)

Flush Mount Rack Kit Installation Procedure 7 of 10
53-1002127-04
Attaching front brackets to a rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack ( Figure 3 ), providing temporary support under the switch until the rail kit is fully
secured to the rack.
2. Attach the right front bracket to the right rack upright using three 10-32 x 5/8-in. screws and three retainer nuts
as shown in Figure 3 .
3. Attach the left front bracket to the left rack upright using three 10-32 x 5/8-in. screws and three retainer nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs. (29 cm-kgs).
FIGURE 3 Attaching front brackets to a rack
5 Screw, 10-32 x 5/8-in., panhead Phillips 6 Retainer nut, 10-32
6
5