STI 9105 User Manual
Page 2
INSTALLATION:
1. DO NOT REMOVE THERMOSTAT. PRIOR TO DRILLING ANCHOR HOLES COVER THERMOSTAT WITH A
CLOTH WETTED WITH WATER TO PREVENT DUST FROM PENETRATING THE SENSOR.
2. CENTER PART No. 9105 FRAME OVER EXISTING THERMOSTAT. MARK AND DRILL (4) ANCHOR
HOLES USING A 1⁄4 in. [6.3mm] DRILL BIT. INSERT THE (4) PART No. 19033 ANCHORS AND
COMPLETE INSTALLATION AS SHOWN.
NOTE: THE (3) TABS ON THE FRAME MUST FACE UPWARD AS SHOWN IN ILLUSTATION ON PAGE 1.
3. INSERT THE (3) TABS ON TOP SURFACE OF FRAME INTO THE (3) SLOTS ON THE COVER, ROTATE
COVER DOWNWARD AND TURN KEY TO LOCK.
CLEANING INSTRUCTIONS
TO CLEAN COVER, REMOVE FROM WALL, RINSE WITH WATER TO REMOVE ABRASIVE DUST AND DIRT.
WASH WITH SOAP OR MILD DETERGENT, USING A SOFT CLOTH (DO NOT SCRUB)
RINSE ONCE MORE, THEN DRY WITH A SOFT CLOTH OR CHAMOIS.
TO REMOVE GREASE OR WET PAINT, RUB GENTLY WITH A CLOTH WETTED THOROUGHLY WITH
NAPHTHA, THEN WASH AND RINSE ONCE MORE. (DO NOT USE RAZOR BLADES)