Stewart Audio CVA100-2 - Manual (Page 9)

9
2.4.2 Unbalanced Input Connections
When using an unbalanced input source and connector, a jumper must
be added between the negative (-) terminals and the ground terminals.
Once this has been done, the unbalanced source can be connected to
the positive (+) and ground terminals. Please refer to the manual of
your input source in case it does not follow the standard pin-out. For
your convenience, pre-wired connectors are available for purchase, see
the next page for details.
NOTE: A jumper is required for connecting an unbalanced
input.
NOTE: The CVA 100-2 does not accept stereo inputs. Either
one side must be selected from the stereo source or an
overload-protected Y-cable must be used to sum them to
mono. It is highly recommended that you purchase the pre
-wired connectors mentioned on the next page. Damage to
source equipment can result from the use of a standard Y-