Stewart Audio CVA100-2 - Manual (Page 8)

8
2.4 Input Connections
Your CVA 100-2 amplifier is provided with a 3-pin Euro Block connector
for each of the two input connection. This connector will accept both
balanced or unbalanced connections, however some modifications
must be made for an unbalanced connection. See the next two sec-
tions for instructions on connecting your amplifier to its input source.
2.4.1 Balanced Input Connections
When using a balanced input source and connector, you must ensure
that the hot, cold, and ground pins of the connector are matched up to
the +, -, and ground pins of the CVA 100-2’s Euro Block connector re-
spectively. Diagrams have been provided for standard XLR and TRS
connectors. Please refer to the manual of your input source in case it
does not follow the standard pin-out.
NOTE: The CVA 100-2 does not accept TRS inputs wired
for a stereo source. TRS inputs should only be used for bal-
anced mono inputs.