Stuart Turner Self Priming Jet 90 Centrifugal - Manual (Page 3)

- 3 -
PRODUCT DESCRIPTION
Motor
Induction type, totally enclosed fan ventilated cooling, continuously rated, class ‘B’
insulation, permanent capacitor, IP 44 enclosure. Motors are fitted with an integral auto-
resetting thermal overload, comply with IEC 34-1 and are suitable for a supply of 230V,
1 phase, 50Hz.
Pump
Close coupled, single stage, end suction configuration and of centrifugal design with
integral Jet injector.
Standard pump materials of construction of major wetted parts are as follows:-
Stuart Turner reserve the right to amend the specification in line with its policy of
continuous development of its products.
Note: For information on other voltages/frequencies which are not shown, consult any
supplementary instruction sheet supplied, or the rating label attached to the
pump.
LIMITS OF APPLICATION
*Note: Max working pressure is the maximum pressure that can be applied to the
pump internal casing under any installation conditions.
TECHNICAL SPECIFICATION
Model Body Impeller Shaft Injector Diffuser Mechanical Seal
All Polypropylene Noryl Stainless Steel Noryl Noryl Nitrile/carbon
Ceramic/Stainless Steel
Model Max.
Water Temp
(°C)
Min.
Water Temp
(°C)
Max.
Ambient
Air Temp
(°C)
Max.
Suction
Lift (m)
Max. Head
(Pump Closed
Valve) (m)
Max. Viscosity *Max.
Working
Pressure
kPa (bar)
Max.
Inlet
Head
(m)
Max. No
Starts/h
(Redwood
No. 1 Scale)
Centistokes
40 35 4 40 7 36.5 50 9.5 600 (6) 5 30
90 35 4 40 7 51 50 9.5 600 (6) 5 30
Model Supply Max. Watts
Consumed Nominal
Watts
Output
(Motor)
Full
Load
Current
(AMPS)
Enc.
Rating
Duty Rating Dims. (mm) Gross
Weight
(packed)
Kg
No of
Pump
Stages
L W H
40 230/1/50 490 340 2.4 IP44 Continuous 358 209 225 7.2 1
90 230/1/50 1200 840 5.2 IP44 Continuous 400 230 230 12.4 1
Cont....