MAHLE RTI BFX-2 - Manual (Page 4)

Page 3
System Priming (First Time Use Only)
Note: System Priming is only necessary before the first time use of the BFX-2.
Connect red (positive) clamp on power cable to red (positive) terminal on vehicle battery. Connect
the black (negative) clamp to a good ground. A good ground can be located by following the negative
cable from the battery to where it is connected to the chassis.
Warning: Handle battery connection cable with extreme caution. Batteries generate
explosive gases during normal operation. Working in the vicinity of a lead-acid or
other automotive battery is dangerous. Wear eye protection. Never smoke or allow
a spark or flame in the vicinity of the battery. Do not connect the black power clip
to the negative post of the battery to avoid a spark.
R T I T E C H N O L O G I E S
B F X - 2
N E W T A N K = # # O Z
S E L E C T P R O C E S S
N E W T A N K E M P T Y
P R E S S C O N T I N U E
S E L E C T N E W T A N K
3 2 O Z 4 8 O Z 6 4 O Z
I N S T A L L B O T T L E
P R E S S C O N T I N U E
³ This will display for five seconds.
Buzzer will beep once. All LED’s will blink on
briefly.
³ This will display.
Connect Fill Gun to Fill Hose.
Disconnect coupler on Used Fluid Tank and
remove cap.
Press FILL MASTER CYLINDER.
Buzzer will beep three times.
³ This will display.
Press CONTINUE
³ This will display.
Use right arrow key | to select size of
new fluid container.
Press CONTINUE
³ This will display.
Install New Fluid Float Switch in bottle of brake
fluid.
Press CONTINUE.