Cut back 0.750, Special hookups – MAHLE RTI VCX-1 User Manual
Page 10
Page 9
PINCH
HOSE
HOSE
PINCH
Overflow
Radiator
Hose
Cut back
0.750
Special Hookups
Seal Tight Radiator
1.
Insert the Adapter Hose into the end of the Cone Plug Adapter.
2.
Place the Cone Adapter snugly into the radiator, coiling the excess length of Adapter Hose at
the bottom.
3.
Follow the Empty Radiator procedure steps 1-9.
More Effective Setup for Empty Radiator
During the Empty Radiator procedure clamp off the upper radiator hose and follow steps 1-9 of the
Empty Radiator section.
Adapter Seal
1.
In some cases it may be necessary to cut up to 0.75" off
of the Cone Plug Adapter. This is only necessary when a
tight seal can not be created due to bottoming out against
the inside of a shallow radiator neck.
2.
Take care to cut a clean edge free of loose debris.
See also other documents in the category MAHLE RTI Accessories for air:
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (16 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)