MAHLE RTI MCX-2F - Manual (Page 12)

Page 11
If the pump is running and the new coolant level does not go down:
Try reversing the connections of the green and black hoses.
FIL L R AD IAT OR & O VE RFL OW
EXC HA NG E C OO LA NT O R
OFF
EM PTY W AS TE TA NK
OF F
& O VER FLO W
FIL L R AD IAT OR
EX CH AN GE CO OL AN T
OFF
EM PT Y W AS TE TA NK
Black Hose
Green Hose
OF F
SY ST EM P RE SS URE
EX CHA NGE CO OLA NT FIL L RA DIA TO R & O VER FLO W
OFF
OFF
SYS TE M V ACU UM
& O VER FL OW
LO WER R AD IATO R
EX CH ANG E C OO L A NT OR
FILL RAD IAT OR & O VE RFL OW
EM PT Y W AST E TA NK
EM PTY WA ST E T AN K
L O WE R R ADI AT OR & O VE RF LO W TES T
Block
Engine
SY STE M V AC UU M
Hose
Adapter
Step
Pump
Water
Overflow
& O VE RFL OW
LO WE R R AD IAT OR TES T
SY STE M P RE SS UR E
Hose
Radiator
Radiator
Adapters
Heater
Core
LO W ER RA DIA TO R
& O VE RFL OW
COOLANT REPLACEMENT
Once the MCX-2F is connected as described on the preceding pages it is ready to
replace the old coolant with new coolant.
Scales for the tank levels are
graduated in quarts and liters
1 Gallon = 4 Quarts.
1. Determine the capacity and type of coolant for the vehicle cooling system. Refer to
the vehicle Owner’s Manual.
2. Make sure the New Coolant Tank (left slot on front) is filled with the correct coolant
and at a level higher than the amount required to fill the coolant system to full
capacity.
3. Check the Waste Tank (right slot on front) to make sure the level is low enough to
accept the full capacity of coolant in the vehicle cooling system.
4. Turn both valves on front of MCX-2F to EXCHANGE.
5. Turn control valve to EXCHANGE COOLANT.
6. Press the top of EXCHANGE COOLANT OR FILL RADIATOR & OVERFLOW
selector switch to turn on the pump.
7. Watch the level of coolant as it lowers in the New Coolant Tank. Press the bottom
of the EXCHANGE COOLANT OR FILL RADIATOR & OVERFLOW selector switch
when it reaches the correct level. This will stop the transfer of coolant.