Audiovox CDM 8410 - Manual (Page 10)

CHARGING THE BA CHARGING THE BA TTER TTER Y Y
NOTE: Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
NOTE: These times are for a new battery.
Talk and standby time may decrease over time.
BATTERY TALK & STANDBY TIMES
BATTERY CHARGING TIME
Chapter 1 - Page 15
CHARGING THE BA CHARGING THE BA TTER TTER Y Y
NOTE: 1. It is more efficient to charge the battery with
the handset powered off.
2. The battery must be connected to the phone
in order to charge it.
3. Battery operating time gradually decreases
over time.
4. If the battery fails to perform normally, you
may need to replace the battery.
Page 14 - Chapter 1
POWER CONNECTION
1. Plug the AC charger into a standard outlet.
2. Plug the other end of the AC charger into the
bottom of your phone. The battery must be installed
on to the phone.
NOTE: 1. When you charge the battery with the phone
power off, you will see a charging status
screen. You cannot operate the phone until
it is powered on.
2. The battery is not charged at the time
of purchase.
3. Fully charge the battery before use.
4. If you use a data cable while you are
charging the battery: After using the
cable, disconnect the AC charger
first, then the data cable.
Battery Type BTR - 8410
200 minutes Charging Time
Standard Battery
(900mAh)
180
103
145
16
Talk Time
(min) Digital
Analog
Digital
Analog
Standby
Time
(hrs)
Charging...
MENU MENU
Charging is
Complete
Charging is
in progress Charging is
in complete
8410altel 2003.12.12 12:25 AM Page 16