Yokogawa DR240 - Manual (Page 81)

4-5 IM DR231-01E
Setting the Monitor Mode Display
4
MANUAL Display for the Main Display
• Channel No., Difference between Channels (delta) and Alarms
Same as for the AUTO mode (refer to page 4-2).
• Measurement Values
Same as for the AUTO mode (refer to page 4-2), except for the following.
When the input type of the channel is set to “SKIP”, then “SKIP” will be displayed.
When the channel other than the channel of the input module is selected, “- - - - - -” appears.
• Engineering Units
Same as for the AUTO mode (refer to page 4-2), except for the following.
When the input type of the channel is set to “SKIP”, then no engineering unit will be displayed.
MANUAL Display for the Sub-display 1 and 2
Data of two channels are displayed here simultaneously on each display.
• Channel No., Difference between Channels (delta), Alarms and Selected Display
Mode
Same as for the AUTO mode (refer to page 4-3).
• Measurement Values
Same as for the AUTO mode (refer to page 4-3), except for the following.
When the input type of the channel is set to “SKIP”, then “SKIP” will be displayed.
When the channel other than the channel of the input module is selected, “- - - - - -” appears.
• Engineering Units
Same as for the AUTO mode (refer to page 4-3), except for the following.
When the input type of the channel is set to “SKIP”, then no engineering unit will be displayed.
4.2 Using the MANUAL Display