Yokogawa IAC-24 Integral Automatic Calibration Unit - Manual (Page 4)

Fig. 3
1.6 Calibration
The IAC-24 does not require flow rate adjustment. Set the inlet pressure to 7 psig +/-2 psig then follow
the calibration setup and execution procedures defined section 9 of the ZR402G or AV550G instruction manual.
1.7 Spare Parts
M1132RR 1/4 NPT SS TUBE ADAPTER
M1234JW-A 3-pin Anphenol connector
4
wired at factory
Pre-wired at factory
All Rights Reserved ©Copyright March 2005, Yokogawa Corporation of America IM 11M12D01-91E-A
Subject to change without notice.