Wright Serial # 63495 and higher - Manual (Page 20)

16
1
4.6 Deck Lift Lever
The “Quick Cut” height selector will adjust the cut height in ¼” increments. To operate, ensure the cutter
deck is in the full up and locked position, insert detent pin (1) in desired cut height hole, grab deck lift handle
and pull back to unlock the deck lift locking mechanism. Lower to the selected cut height.
4.7 Safety Interlock System
The Wright Stander X is equipped with a safety interlock system. The PTO must be disengaged, brake
applied and control levers in the neutral position in order to start the machine. With the brake applied, the
controls are locked in the neutral position.
Deck Lift
Handle
Parking brake applied,
locks control levers
Parking brake
safety switch