Pfister RT6-3DFC - Manual (Page 4)

ENGLISH
ENGLISH
17
15
12 10
11
13 16
10 VALVE FLANGE INSTALLATION
Place Plastic Base (10A) and Flange (10B) over Valve Body (10C) covering the Valve
Body Washers (10D). Secure by threading the Plastic Nut (10E) onto the Valve Body
(10C).
11 HANDLE INSTALLATION
Before proceeding, Valve Stems (11B) are to be set in the closed position.
Screw Stem Extender (11A) onto the Valve Stem (11B). Attach Handle Hubs (11C) onto
Valve Stems (11B) and tighten Set Screws (11D). Make sure Set Screw (11D) is securely
tightened to handle (11C). Place Button (11E).
12 HOSE GUIDE INSTALLATION
Remove Clip (12A) and Plaster Guard (12B) from Spray Hose (12C).
Do not let Spray Hose (12C) retract down into deck.
From underneath deck, slide Washer (12D) and Locknut (12E) into Spray Hose (12C)
as shown. From above deck, insert Hose Guide (12F) onto Spray Hose (12C) and into
the side hole. From underneath deck, secure Hose Guide (12F) by screwing Locknut
(12E).
13 DECORATIVE HOSE ATTACHMENT
Apply PTFE plumber’s tape to threaded end of Decorative Hose (13A) according to
manufacturer’s instructions. Attach Spray Hose (13B) to Decorative Hose (13A).
4
3 15 / 32 ”
(88 mm)
15A 15B
15A
15C
12F
12B
12A
12C
12D
12E
10E
10B
10A
10C
10D
10D
10C
10E
10A
10B
11A
11A
11B
11B
11C
11C
11D
11D
11E
13A
13B
16D
16A
16B
16C