Proface APL3000B - Node Box PC - Manual (Page 35)

PS-3710A / PS-3711A Reference Manual
2-12
Onboard Serial Port 4 (Not displayed with the PS-3711A)
Specifies an enabled/disabled state for the COM4. Select from [Disabled] or [Enabled]. The factory default setting
is [Enabled]. In addition, the factory default setting for Base I/O Address is [2E8], and for Interrupt is [IRQ 10].
Floppy disk controller (Not displayed with the PS-3711A)
Specifies the floppy disk parameters. Select from [Disabled], [Enabled], or [Auto]. The factory default setting
is [Enabled]. In addition, the factory default setting for Base I/O Address is [Primary].
„ Keyboard Features
Specifies the keyboard-related parameters. Point the cursor to the [Keyboard Features] on the [Advanced
Chipset Control] and press the [Enter] Key, so that the following screen will be displayed.
NumLock
Specifies the NumLock status. Select from [Auto], [On], or [Off]. The factory default setting is [On].
KeyClick
Specifies an enabled/disabled state for the keyboard’s click sound. Select from [Enabled] or [Disabled]. The
factory default setting is [Disabled].
Keyboard auto-repeat rate
Specifies the figures of how many times a key can input letters while being pressed for a second. Select from
[30/sec.], [26.7/sec.], [21.8/sec.], [18.5/sec.], [13.3/sec.], [10/sec.], [6/sec.], or [2/sec.]. The factory default
setting is [30/sec.].
Keyboard auto-repeat delay
Specifies a time duration until the auto-repeat function becomes enabled from a key is pressed. Select from
[1/4 sec.], [1/2 sec.], [3/4 sec.], or [1 sec.]. The factory default setting is [1/2 sec.].