Proface APL3000B - Node Box PC - Manual (Page 34)

Chapter 2 System Setup
2-11
„ I/O Device Configuration
Specifies the address and interrupt level of the I/O ports. Point the cursor to the [I/O Device Configuration] on
the [Advanced] screen and press the [Enter] Key, so that the following screen will be displayed.
Onboard LAN 1, 2
Specifies an enabled/disabled state for the Onboard LAN 1,2. Select from [Enabled] or [Disabled]. The
factory default setting is [Enabled].
Onboard Cardbus Controller
Specifies an enabled/disabled state for the PCMCIA slot. Select from [Enabled] or [Disabled]. The factory
default setting is [Enabled].
Onboard Serial Port 1
Specifies an enabled/disabled state for the COM1. Select from [Disabled] or [Enabled]. The factory default
setting is [Enabled]. In addition, the factory default setting for Base I/O Address is [3F8], and for Interrupt is
[IRQ 4].
Onboard Serial Port 2
Specifies an enabled/disabled state for the COM2. Select from [Disabled] or [Enabled]. The factory default
setting is [Enabled]. In addition, the factory default setting for Base I/O Address is [2F8], and for Interrupt is
[IRQ 3].
Onboard Serial Port 3 (Not displayed with the PS-3711A)
Specifies an enabled/disabled state for the COM3. Select from [Disabled] or [Enabled]. The factory default
setting is [Enabled]. In addition, the factory default setting for Base I/O Address is [3E8], and for Interrupt is
[IRQ 11].