Ramsey Winch RPH-50000 LARGE FLANGE W/AIR TENSIONER (OBSOLETE) - Manual (Page 14)

11
10. Set gasket #38 into place on gear housing end bearing #10. Place ring gear onto end bearing,
aligning holes in ring gear with holes in gasket and gear housing end bearing. Use (2)
capscrews to temporarily secure ring gear to end bearing. Place (2) gear carrier assemblies into
ring gear meshing carrier gears with ring gear. Slide input sun gear over shifter shaft #13 and
mesh with teeth of input carrier. Apply grease to input thrust washer and place into slots of
gearbox cover. Place gasket #38 into position on gearbox cover with sealer. Remove (2)
temporary capscrews and attach cover and gasket to ring gear end bearing. Use (12) capscrews
#16 to secure gearbox to gear housing end bearing. Torque capscrews to 87 ft.-lbs. each, in a
criss-cross pattern.
11. Pull rod from air cylinder as far as possible. Slide washer #28 over setscrew #21 and against nut
attached to air cylinder rod. Place setscrew into hole of shifter shaft #13 and attach air cylinder
to gear box cover using (4) capscrews #23. Apply Loc-tite PST thread sealer to threads of
capscrews. Torque capscrews to 5 ft.-lbs. each, in criss-cross pattern.
15
16
38
COVER
GEAR HOUSING
RING GEAR
10
13
21
28
27
42
36
40
33
23
13