Ramsey Winch RPH-50,000 (AATAC) - Manual (Page 14)

12
14. Apply Permatex to threads of plug (item #42). Thread plug into tapped hole in bottom of gear housing end bearing
(item #8). Pour approx. 2.50 pints of SAE 80W-140 oil into end bearing. Check oil level by removing oil plug noted
below. Insert relief fitting (item #37) and thread reducer (item #41) into end bearing at oil fill hole. Be sure breather
vent (item #38) is not damaged and in good operating condition. Replace if necessary.
Install winch and connect pressure lines. Apply at least 230 PSI pressure to release brake and verify that brake re-
leases, by observing that the winch drum rotates.
15. Check proper operation of clutch by applying air pressure to clutch air cylinder to disengage clutch. Verify that winch
freespools. Re-engage clutch. A loud noise should be heard when clutch engages. Winch drum should not freespool.
16. Operate winch forward and reverse to verify that drum rotates.
38
OIL LEVEL PLUG
37
42
8
41