Ramsey Winch HDG-350 (JERR-DAN) (NOT CURRENT) User Manual

Page 16

15.Place thrust washer (item #62) over

end of drum shaft and slide downward
until spacer rests on drum. Press drum
downward to compress springs in gear
housing.

Insert keys (item #43) into keyways
with sharp edge of keys pointing out-
ward and notched end of keys upward.
A rubber or brass mallet will be needed
to gently tap keys into position.

Apply grease to keys and end of shaft.
place jaw clutch (item #6) over end of
shaft and slide jaw clutch over keys.

Set clutch housing (item #14) over end
of drum shaft. Pull jaw clutch (item #6)
upward, toward clutch housing, enough
to allow yoke, in clutch housing, to fit
properly in groove around jaw clutch.

16.Attach frame assembly (item

#1) using six capscrews
(item #30) with lockwashers
and two capscrews (item
#29) with lockwasher. Torque
capscrews to 34 ft. lbs. (46
Nm.) each. Insert plug (item
#48) into bottom of gear
housing. Permatex may be
applied to threads to help pre-
vent leakage.

Attach adapter rod (item #38)
to clutch shaft using pin (item
#49).

Pour 1 pint of SAE 140 EP gear oil into
housing through hole in top of housing.
Pipe plug (Item #47) should then be
placed into hole on top of gear housing.
Tighten securely.