Ramsey Winch HDG-350 (JERR-DAN) (NOT CURRENT) - Manual (Page 12)

3. Remove motor and coupling (item #7)
from (item #3) adapter by unscrewing
two (item #33) capscrews with lock-
washer.
Remove key (item #16) from worm
shaft. Unscrew four capscrews (item
#32) and remove adapter from gear
housing. Replace adapter seal (item
#54) and gasket (item #40).
4. See page 7 for servicing the oil
cooled brake. Remove brake
housing from gear housing by
unscrewing four capscrews
(item #31). Remove worm
(item #19) and bearings (item
#21) from gear housing. Use
soft hammer to gently tap input
end of worm and drive worm
and bearing from gear housing.
Once worm has been removed from housing,
bearing can be pressed from end of worm.
Check for signs of wear or damage to worm (item
#19) and bearing (item #21). Replace if neces-
sary.
5. Remove gear housing cover (item #9)
from gear housing (item #13) by unscrew-
ing capscrews (item #26). Thread two of
the capscrews into the two tapped holes of
cover and tighten. This will pull the cover
loose from gear housing.
Remove cover gasket (item #42) and pull
shaft (item #18), with gear attached, and
thrust washer (item #62) from gear hous-
ing.
12