Ramsey Winch HD-200 (JERR-DAN) User Manual

Page 14

13. Press bearing (item #14) onto worm and into housing. NOTE: Be

sure that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away from worm
threads. Place gasket (item #29) onto adapter (item #3). Attach
adapter to gear housing using four (4)
capscrews (item #22). TIGHTEN
CAPSCREWS TO 12 FT. LBS. (16.3 Nm.)
EACH. Insert key (item #11) into keyway
of worm shaft. Slide tapered end
of coupling (item #27) over end
of worm shaft. Be sure roll
pin (item #38) is in coupling.

Place motor shaft, with
key in keyway, into coupling.
Secure motor to adapter, using
two (2) capscrews (item #23)
and lockwashers. TIGHTEN
CAPSCREWS TO 75 FT. LBS.
(102 Nm.) EACH.

14. Place winch with gear housing cover down on work bench. Drum

shaft should be in vertical position. Slide thrust washer (item #45)
over drum shaft and slide downward until washer rests on gear
housing. Set springs (item #43) into pockets of gear housing with
drag brakes (item #28) on top of springs. Slide drum assembly
(item #7) onto drum shaft with drum jaws upward.