Ramsey Winch HD-200 (JERR-DAN) - Manual (Page 13)

10. Check cover bushing (item
#15) for signs of wear. If
necessary remove old bushing
and press bushing into place.
RE-ASSEMBLY
11. Apply grease to end of shaft, opposite gear. Apply grease to
bushing in gear housing (item #10). Place greased end of shaft
through thrust washer (item #46) and bushing in gear housing
(item #10). Place gasket (item #30) onto gear housing
cover (item #6). Apply
grease to gear end of shaft
and cover bushing. Place
cover onto shaft and secure
to housing with ten
(item #18) capscrews.
Tighten capscrews to
8 ft. lbs. (10.8 Nm.) each.
12. Press bearing (item #14) onto worm (item #13). NOTE: Be sure
that thick shoulder of bearings outer race (side with
manufacturer's name and part number) is out, away from worm
threads. Press bearing and worm into gear housing. Slip gasket
(item #29) onto bearing cap (item #4). Use four capscrews (item
#19) to secure cap to gear housing. TIGHTEN CAPSCREWS
TO 8 FT. LBS. (10.8 Nm.) EACH.
10