Ramsey Winch RPH 10000T - Manual (Page 15)

13
Before installing motor, check brake adjustment (refer to page 7, ADJUSTING THE BRAKE).
Place splined end of coupling (item #31), with spirol pin installed, inside of motor end bearing
housing (item #7) and slide over splines on end of input shaft. Place o-ring (item #38) around
motor pilot. Mount motor (item #35) to end bearing by aligning key on motor shaft with
keyway in coupling. Be sure that motor mounts flush to end bearing and that o-ring is set
securely in place between motor and end bearing. Secure motor to end bearing using two
capscrews and lockwashers (items #24 & #30). Tighten capscrews to 49 Ft. Lbs. (66 Nm).
Thread plug (item #40) into bottom of brake housing. Permatex can be added to threads of
plug to help in sealing. Pour a mixture of 8 oz. of Mobilfluid 424, Phillips HG Fluid, Texaco
TDH, Shell Oil Co. Donax TD high performance tractor transmission fluid, or equivalent and
1/4 oz. of an additive (available from the factory), into oil level hole. Oil level should be kept at
oil level hole (plus or minus 1/8"). Thread plug (item #40) into oil level hole. Insert reducer
(item #39) into hole in top of brake housing and breather plug (item #34) into reducer. Tighten
plugs and reducer securely.