Ramsey Winch RPH 10000T - Manual (Page 11)

9
Remove tie plates (item #13) from end bearings (items #7 & #8) by unscrewing capscrews (item
#18), as shown. Slide motor end bearing (item #7) from drum (item #1) and drum from gear
housing end bearing (item #8). Remove input shaft (item #12) from end bearing. Inspect teeth of
gear (item #5) for signs of wear. If necessary replace gear by removing snap ring (item #47) and
thrust washer (item #50) . Slide new gear over splines of shaft and against snap ring on shaft. Re-
install thrust washer and place snap ring into groove of shaft.