Ramsey Winch FORD WRAPAROUND KIT 295356 (RPH 12000) - Manual (Page 5)

4
STEP 4
Remove base tie bars from bottom of winch end bearings. Place winch in cavity of frame #3 on top of
mounting plate. Place (2) base tie bars between the rear winch feet and the mounting plate. Place
the other two base tie bars between the front winch feet and the mounting platform. Secure using (8)
1/2-13NC X 1-1/2 lg. hex hd. capscrews inserted through 1/2” lockwashers then through mounting
plate, base tie bars, and into tapped holes in winch feet. Tighten securely. (See torque value chart,
page 6).
Install remaining bottom tube assembly #6 between side plates #2, placing shims #23 between side
plates and ends of tube. Secure using (1) 3/8-16 NC X 3/4 lg. hex socket button head capscrew #17
at each end.
Tighten all hardware to proper torque value (see Torque value chart, page 6).