Ramsey Winch FORD WRAPAROUND KIT 295356 (RPH 12000) - Manual (Page 2)

1
STEP 1
Unfasten plastic splashguard from radiator support bracket. Remove vehicle tow hooks and vehicle
bumper. Remove and discard shims hanging from front of vehicle frame.
Enlarge rectangular cutout in bumper bracket by 1/2" at top and 1/4” at bottom. See REAR VIEW OF
BUMPER below.
Attach nut plate #4 to inside of bracket assembly #7 & #8 using (2) 1/2-13NC x 1-1/4 lg. capscrews
#16 with lockwashers #21, and flatwashers #22, in the two front holes each side.
You will need assistance for this step.
While holding bumper in place, install end of R.H. and L.H. bracket assemblies through bumper and
bumper brackets and into ends of R.H. and L.H. vehicle frame. Secure brackets to front of frame
using (2) 1/2-13NC x 1-1/2 lg. capscrews #13, with lockwashers #21, nuts #19 and nut strips #1, each
side. DO NOT TIGHTEN HARDWARE COMPLETELY.