Ramsey Winch CHEVY GRILL GUARD KIT 295365 - Manual (Page 4)

10. Install grille tube (Item #2) between side plates
(Item #1). Insert (1 each side) shim (Item #14)
between tube and side plate at each end. Secure
using (1 each side) 3/8-16NC X .75 long button
head capscrew (Item #9) through side plate and
into threaded hole in each end of tube.
11. TIGHTEN ALL HARDWARE COMPLETELY. Start at
the grille tube and work down to the lower bracket
assemblies tightening all hardware to the appropriate
torque value. (See Torque Value Chart).
12. If needed, install License Tag Bracket (Item
#16) to underside of winch channel (Item
#3) using (2) 1/4-20NC X 1.0 LG HX HD
F/B GR5 bolts (Item #20), (2) 1/4 nuts
(Item #18), and (2) 1/4 lock washers (Item
#19). Refer to drawing at right.
13. Install license tag to License Tag Bracket
using (2) 1/4-20NC X 0.5 LG HX HD F/B
GR5 bolts (Item #17). Using (2) 1/4 flat
washers (Item #21) if needed for spacing.
14. Lift the winch into the winch channel (Item
#3).
15. Using hardware supplied with the winch,
install two sets of the mounting bolts 1)
through the slots underneath the channel
and 2) on the the upper front slots loosely.
16. Install fairlead using hardware furnished with winch.
As shown at right, note that mounting bolts should
go through 1/2” holes (turn so that these holes are
on top) in roller fairlead and slots in winch channel
then into the feet of the winch.
4
9
2
14
1
View from Underside
of Winch Channel
5
18 19 20
17 21
Tip: To orient fairlead,
make sure chamfered
edge is at lower left.
Install bolts through upper
(1/2”) bolt hole in fairlead,
slot in winch channel, and
into winch leg.