Ramsey Winch CHEVY GRILL GUARD KIT 295365 User Manual
Page 2
1. Remove the three M12 bolts that secure the vehicle tow
hook. They are located on either side and on the bottom
of the frame (See figures above).
2. Remove the tow hook and set it aside.
3. Install left hand bracket (Item #4) by inserting it through
the existing tow hook access in the air dam.
4. Install 1/2-13NC X 1.25” hex head bolt (Item #11), lock-
washer (Item #16), & flat washer (Item #17) through
bottom hole in frame and into captive nut in bracket.
Figure below shows underside of frame and bracket.
5. Insert 1/2-13NC X 4.5” hex head bolt (Item #9) through
hole in frame (this is where the tow hook was unbolted
in step 1) and through bracket #4. Secure using lock-
washer (Item #16) & nut (Item #14).
2
Note: It is not necessary to remove the vehicle bumper to install
this mounting kit.
Note: In two-wheel drive models that do not have front tow hooks, it
will be necessary to cut through bumper for access to frame. From the
underside of the vehicle, mark a starting point from a corner of the end
of the frame. Make a rectangular cut 3.25” wide from the top of the
pocket to the bottom (approximately 3-3.25” high, as shown at right).
The cut does not have to be exact, as the hole will be covered by the
grille guard.
3.25”
~3-
3.25”
CUTOUT FOR TWO-WHEEL DRIVE MODELS
FOUR-WHEEL DRIVE MODELS
(NO CUTOUT REQUIRED)