Ramsey Winch CHEVY GRILL GUARD KIT 295358 (RE WINCH) - Manual (Page 3)

KI-913357-1002-C 2
Figure 4
Step 4
Repeat Step 1 through Step 3 for right hand side of vehicle. Tighten hardware to the appropriate
torque value (See Torque Value Chart on page 5).
Step 5
Remove shipping strap and mounting bolts from winch assembly and discard. Place frame assembly #2 over top of
winch and secure. Use (3) 3/8-16NC x 1” hex head
capscrews #9 with lockwashers #19 and (1) 3/8-
16NC x 3/4” socket head capscrew #14 with 9/16”
high collar lockwasher #20 to attach winch to rear
angle of frame assembly (Figure 4). DO NOT TIGHTEN.
Attach winch to front angle of frame assembly using (3)
3/8-16NC x 1” socket head capscrews #13 with high
collar lockwashers (9/16 OD) #20 and (1) 3/8-16NC x
3/4” socket head capscrew #14 with 9/16” high collar
lockwasher #20 as shown in Figure 4. Note: The (2)
outer-most capscrews are inserted through holes in
face of mounting frame and threaded into winch. The
(2) inner-most capscrews are placed through fairlead
opening and threaded into winch. Tighten front
hardware to appropriate torque value, then tighten
back hardware (See Torque Value Chart on page
5). Snap hole plugs #25 into outer-most holes in front
of frame assembly.
Step 6
NOTE: YOU WILL NEED ASSISTANCE FOR THIS STEP.
Have someone hold the winch and mounting frame #2 between the left and right brackets. Position
left-hand side plate assembly #1 at the outside of the winch mounting frame (Figure 5). Insert (3) 1/2-
13NC x 1-1/2” carriage bolts #11 through the holes in side plate #1, through frame mounting bracket
#5, and through the mounting frame. Secure using (1) lockwasher #21 and nut #18 for each carriage
bolt. Do not tighten completely. Repeat for the right hand side plate.
Figure 5