Ramsey Winch CHEVY GRILL GUARD KIT 295358 (RE WINCH) - Manual (Page 2)

KI-913357-1002-C 1
Figure 2
Figure 3
Step 1
Note: It is not necessary to remove or modify the vehicle bumper to install this mounting kit.
Remove the three M12 bolts that secure the vehicle tow hook. They are located on either side and on the bottom of
the tow hook (Figure 1). Remove the tow hook and set it aside.
Step 2
Install left hand bracket #5. Bracket is inserted through the existing
tow hook access in the air dam (Figure 3). Install 1/2-13 NC x 1-1/4
hex head bolt #12, lockwasher #22, & flat washer #23 through
bottom hole in frame (see Figure 2) and into captive nut in bracket #5.
Step 3
Insert 1/2-13NC x 4-1/2” hex bolt #10 through hole in frame (this
is where the tow hook was unbolted in step 1) and through bracket
#5 at location shown in Figure 3. Secure using lockwasher #22 &
nut #17.
Place vehicle tow hook into the front section of bracket #5 (See
Figure 5), and secure using existing tow hook mounting hardware
removed in step 1 at sides and bottom of tow hook.
Figure 1