Ramsey Winch FORD WRAPAROUND KIT 295918 - Manual (Page 7)

KI-913348-0301-B 6
Step 11
Note: You will need assistance for this step.
Remove (2) 3/8-16NC x 1-1/2” lg. hx. hd. capscrews #14 from
L.H. side of center unit where channel attaches to side plate.
Remove the two nuts #17, plastic washers #20, and capscrews
#12 that secure the headlight grille to the wraparound #4.
Have someone position wrap shim #33 between the side plate
and wraparound. Install (1) ¼-20NC x 1” lg. hx. hd. capscrew
#12 through upper hole in wraparound and into side plate.
Secure using nut #17. Do not tighten.
Re-insert (2) 3/8-16NC x 1-1/2” lg. hx. hd. capscrews #14 through light tube, shim, side plate, and
channel and secure with nut #18 (Figure 18). Tighten all hardware to proper torque. (See torque
value chart, page 9).
Re-insert (2) ¼-20NC x 1” lg. hx. hd. capscrews #12 through plastic washers #20, headlight grille,
wraparound, and side plate. Secure using nut #17. Tighten to proper torque.
Repeat for R.H. side.
Step 12
Install fairlead as shown below. Note that top holes in channel (Figure 19) align with bottom
holes on roller fairlead (Figure 20). Secure using capscrew, lockwasher, and nut furnished with
winch.
Figure 18
Figure 19
FURNISHED WITH WINCH
Figure 20
FURNISHED WITH WINCH