Ramsey Winch FORD WRAPAROUND KIT 295918 - Manual (Page 6)

KI-913348-0301-B 5
Step 9
Note: You will need assistance for this step.
Have someone steady the center unit while you insert winch
mounting channel #2 between side plates of center unit #5.
Channel shims #26 are inserted between the end of the channel
and the side plate of the center unit on both sides. Use a rubber
mallet to tap the channel into place. Secure channel using (2) 3/8-
16NC x 1-1/2 lg. hx.hd. capscrews #14 with locknuts #18 (each
side). Note: Do not tighten hardware at this location as you will
need to remove these capscrews in a later step.
Step 10
Insert the lower tabs of the center unit through the cutouts in the bumper. Position upper shims
#30 on top of the frame mounting brackets, then secure the channel to the frame mounting
brackets (Figure 16). Use (2) 3/8-16NC X 1-1/4” capscrews #13 with locknuts #18 each side. Do
not tighten hardware. Slip lower shim #34 between the lower tab on side plate and the frame
mounting bracket (Figure 17). Install (2) 3/8-16NC X 1-1/4” capscrews #13 through lower holes
in L.H. side plate and frame mounting bracket (Figure 17). Secure with nuts #18. Repeat for
R.H. side.
Figure 15
Figure 16
Figure 17