Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295942 & 295943 User Manual

Page 5

IF NOT INSTALLING GRILLE GUARD KIT #295942,
SKIP STEPS 7-8

7. Place wrap shim (item #28) between Wraparound

units and side plates of center unit. Install right and
left Wraparound units (items #7 and #9) to side
plates of center unit using (3 per side) 1/4 x 1 cap-
screws (item #13), (6 per side) 1/4 flat washers, and
(3 per side) 1/4 locknuts. Do not tighten until later.

8. Install right and left Headlight Grilles (items #6 and

#8) to Wraparound units and side plates of center
unit using (2 per side) 1/4 x 1 capscrews (item #13),
(4 per side) 1/4 flat washers, and (2 per side) 1/4
locknuts. Far end of Headlight Grilles snap onto
Wraparound units. Do not tighten until later.

9. If needed, install the License Plate Assembly (item

#23) to the underside of the Channel (item #22)
using (2) 1/4 x 1 capscrews (item #13).

10. Align and tighten all bolts to proper torque (see

chart at right).

11. Install the fairlead using hardware furnished with the

winch. Refer to winch owner’s manual for complete
instructions. Tighten fairlead mounting bolts to proper
torque.

12. Install the winch in the Channel according to mounting

instructions in the winch owner’s manual, using hard-
ware furnished with winch. Do not tighten mounting
bolts until electrical connections are complete.

13. Refer to winch owner’s manual for electrical connec-

tions. Push battery cables into loom (item #25) and
secure using cable ties (item #24) at each end of
loom. To improve appearance, wrap end of loom with
electrical tape.

Torque Value Chart

Bolt

Torque,

Size

ft-lbs.

1/4-20

9.7

3/8-16

7/16

10 mm