Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295942 & 295943 - Manual (Page 4)

4
4. Lift center unit (item #1) into place between
lower mounts (with center unit outside brack-
ets). Lift winch channel (item #22) between
lower mounts. Place channel and lower mount
gaskets (item #26) between center unit and
lower mounts, and between channel and lower
mounts. Secure using (2 per side) 3/8 x 1-1/4”
capscrews (item #11), (4 per side) 3/8 wash-
ers (item #18), and (2 per side) 3/8 locknuts
(item #19). Do not tighten until later.
For 2006-2007 Ford F-150, see additional instruc-
tions on the following page.
5. Remove the 10 mm bolt that is located on
either side of vehicle on the back side of
bumper as shown at right. The bolt will be
located approximately 2” inside of grille guard
plates. Hint: Lift upper support bracket into
place to help locate.
Passenger side shown.
6. Fasten upper support (item #4) using 10mm
x 40 mm capscrew (item #12) in place of
existing hardware. Upper support should rest
on top of bumper and align with hole in center
unit (item #1). Place upper support gasket
(item #27) between upper support and center
unit. Use (1) 3/8 x 1-1/4” capscrew (item
#11), (2) 3/8 washers (item #18) and (1)
3/8 locknut to secure upper support to center
unit. Do not tighten until later.
Repeat steps 5 and 6 for other side.