Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295942 & 295943 - Manual (Page 2)

FOR ALL VEHICLES WITHOUT FRONT TOW HOOKS, START
ON THIS PAGE.
FOR ALL VEHICLES EQUIPPED WITH FRONT TOW HOOKS,
START ON FOLLOWING PAGE.
Cut 2 L-shaped slots 4” x 3” 28-1/4” apart, centered on the
vehicle (in the bumper cavities), as shown at right. The right
and left lower mounting brackets will need to be inserted
through these slots, so use the lower mounts as guides to cut
slots.
Insert (2) 7/16 bolts with extensions (item #10) into round
openings on each side of each frame rail (one bolt for front
hole and one bolt for back hole). Once bolts extend through
bottom of frame rail, fasten lower mounting bracket (item #2)
using (2) 7/16 flat washers (item #16), (2) 7/16” lockwash-
ers (item #15), and (2) 7/16 hex nuts (item #17). Do not
tighten until later.
Do the same on the right side of vehicle.
Continue with installation on Page 4.
2
FRAME RAIL