Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295344 & 295345 (RE WINCH) - Manual (Page 8)

STEP 3
7
Attach license tag brackets (item #3) to bottom, R.H. side, of channel using (2) 1/4-20NC x 3/4 lg.
self tapping capscrews with lockwashers. Attach tag to brackets using (4) 1/4-20NC x 1/2 hx.hd.
capscrews with lockwashers and nuts. Tighten all hardware to proper torque value (see TORQUE
VALUE CHART).
Place (2) 3/8-16NC x 1-1/4 lg. capscrews through lower-most holes in frame assembly from inside of
channel. Secure fairlead to capscrews using (2) 3/8 lockwashers and nuts. Tighten hardware to
proper torque value (see TORQUE VALUE CHART).
Refer to winch Owner's Manual Installation Instructions for electrical connections. BE SURE
BATTERY CABLES ARE NOT DRAWN TAUT ACROSS ANY SURFACES WHICH COULD
POSSIBLY DAMAGE THEM. Push battery cables into loom #33 and slide loom up cable as close
as possible to winch mounting frame. Secure loom to cable using (1) cable tie #30 at each end of
loom. To improve appearance, wrap ends of loom with black electrical tape.
Plug remote switch into receptacle of black solenoid cover of winch. Run winch forward and reverse
to check connections. Snap appropriate "IN" and "OUT" disc into proper thumb cavity, after
determining winch operating direction. DO NOT LEAVE SWITCH PLUGGED IN WHEN WINCH IS
NOT IN USE.
Place end of wire rope through fairlead and attach clevis hook. Use clevis pin and cotter pin
(furnished with winch).
REFER TO WINCH OWNER'S MANUAL FOR SAFE OPERATIONS.