Ramsey Winch FORD GRILL GUARD/WRAPAROUND KITS 295344 & 295345 (RE WINCH) - Manual (Page 2)

STEP 1
1
Figure 3
1. Unfasten plastic splashguard from radiator support bracket. Loosen, but do not remove, the
two bolts on the arms of the bumper support bracket as shown in Figure 1. Remove the bolt
attached to the vehicle frame. Repeat for other side of vehicle. Remove tow hooks and
vehicle bumper. Remove and discard shims hanging from front of vehicle frame, if so
equipped.
2. Next remove the two bolts on the left side of the blocker
bar as shown in Figure 2. Remove the three nuts on the
underside of the blocker bar as shown in Figure 3.
Repeat for other side of vehicle and remove blocker bar.
On some models, to remove the blocker bar, remove the
four bolts that hold the blocker bar to the bracket as
shown in Figure 3a.
Figure 1 Figure 2
Figure 3a