Ramsey Winch DODGE GRILL GUARD/WRAPAROUND KITS 295938 & 295939 - Manual (Page 2)

Note: If the vehicle is equipped with a
diesel engine, raise hood and remove (2)
bolts on the oil cooler. It will be necessary to
lift cooler to allow access to frame and bumper
bolts in the next steps.
If vehicle is not diesel, proceed to step #1.
Note: It is not necessary to remove the airdam in order to modify it or
install the kit. The following pictures show the airdam removed for clarity
only.
1. Cut notches in air dam for the Lower Mounting Brackets to fit through. Cut
1/2” wide notches from the bottom of the top lip of the air dam, cutting
through the bottom lip of the air dam. As shown below, the spacing of the
notches is 16 3/16” from center to outside of notch. The best way to meas-
ure the center of the air dam is to measure from the License Plate mounting
bolt holes. Find the center between the holes, and mark it as your center of
the air dam.
The 1/2” width of the notch does not allow any clearance of the bracket that
fits through it. You may need to trim it slightly after you have the bracket
installed, but you will want the fit as tight as possible.
2
3
1
2
1
2
1
2
16 3
16
16
3
16
Air dam
License Plate
Mounting Holes
Cut Notch
Here